CONVERT FLASH TO USB USING CMD

 Step 1: Open cmd through run as administrative

Step 2: Type DISKPART

Step 3: Type LIST DISK

Step 4:  Type SELECT DISK <N> and press enter. (where N is your disk number it maybe 0,1,2….). For example: if your disk number is ‘1’ then type SELECT DISK 1

Step 5: Type CLEAN and press enter.

Step 6: Type CREATE PARTITION PRIMARY and press enter.

Step 7:    Type ACTIVE and press enter.

Step 8: Type FORMAT FS=FAT32 QUICK and press enter. Wait for few seconds until the format process reaches 100 percent.

Step 9:   Type ASSIGN and press enter.

Step 10. Then type EXIT and press enter. Again type EXIT and press enter.